Ipv6 Prefix-List - Allied Telesis IE340 Series Command Reference Manual

RIP IP 6 C
NG FOR V OMMANDS
6 -
IPV PREFIX LIST

ipv6 prefix-list

Overview Use this command to create an IPv6 prefix list or an entry in an existing prefix list.
Use the no variant of this command to delete a whole prefix list, a prefix list entry,
or a description.
Syntax ipv6 prefix-list <list-name> [seq <1-429496725>] {deny|permit}
{any|<ipv6-prefix>} [ge <0-128>] [le <0-128>]
ipv6 prefix-list <list-name> description <text>
no ipv6 prefix-list <list-name> [seq <1-429496725>]
no ipv6 prefix-list <list-name> [description <text>]
Mode Global Configuration
Usage notes When the device processes a prefix list, it starts to match prefixes from the top of
the prefix list, and stops whenever a permit or deny occurs. To promote efficiency,
use the seq parameter and place common permits or denials towards the top of
the list. If you do not use the seq parameter, the sequence values are generated in
a sequence of 5.
The parameters ge and le specify the range of the prefix lengths to be matched.
The parameters ge and le are only used if an ip-prefix is stated. When setting these
parameters, set the le value to be less than 128, and the ge value to be less than or
equal to the le value and greater than the ip-prefix mask length.
Prefix lists implicitly exclude prefixes that are not explicitly permitted in the prefix
list. This means if a prefix that is being checked against the prefix list reaches the
end of the prefix list without matching a permit or deny, this prefix will be denied.
C613-50631-01 Rev A
Parameter
<list-name>
seq <1-429496725>
deny
permit
<ipv6-prefix>
any
ge <0-128>
le <0-128>
description
<text>
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
Specifies the name of a prefix list.
Sequence number of the prefix list entry.
Specifies that the prefixes are excluded from the list.
Specifies that the prefixes are included in the list.
Specifies the IPv6 prefix and prefix length in hexadecimal
in the format X:X::X:X/M.
Any prefix match. Same as ::0/0 le 128.
Specifies the minimum prefix length to be matched.
Specifies the maximum prefix length to be matched.
Prefix list specific description.
Up to 80 characters of text description of the prefix list.
1081