Power-Inline Hanp - Allied Telesis IE340 Series Command Reference Manual

P E C
OWER OVER THERNET OMMANDS
-
POWER INLINE HANP

power-inline hanp

Overview Use this command to enable High Availability Network Power (HANP), also known
as Continuous PoE. Continuous PoE enables the switches to perform actions such
as software upgrades without forcing the Powered Devices to power cycle. This
means, for example, if you are rebooting a switch connected to a PD such as a
camera, Continuous PoE allows the camera to buffer while the switch is rebooted.
You can configure it on a global or per port level. Enabling it globally enables it on
all PoE ports.
Use the no variant of this command to disable Continuous PoE globally or on the
specified ports.
power-inline hanp
Syntax
no power-inline hanp
Default Continuous PoE is disabled globally by default. If you enable it globally, that
enables it on all ports.
Mode User Exec/Privileged Exec or Interface Configuration for a PoE port
Example To enable Continuous PoE on all ports, use the commands:
awplus#
awplus(config)#
To enable Continuous PoE on all ports except port 1.0.5, use the commands:
awplus#
awplus(config)#
awplus(config)#
awplus(config-if)#
Related show power-inline
commands
show power-inline interface
show power-inline interface detail
Command Version 5.4.6-2.1: command added
changes
Version 5.4.7-0.1: added to x930 series products
Version 5.4.8-0.2: added to x550 series products
Version 5.4.8-2.1: added to x220 series products
C613-50631-01 Rev A
configure terminal
power-inline hanp
configure terminal
power-inline hanp
interface port1.0.5
no power-inline hanp
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
817