OSPF C
OMMANDS
BANDWIDTH
bandwidth
Overview
Use this command to specify the maximum bandwidth to be used for each
interface. The bandwidth value is in bits per second. OSPF uses this to calculate
metrics for the interface.
The no variant of this command removes any applied bandwidth value. It replaces
it with a value equal to the lowest port speed within that VLAN.
bandwidth <bandwidth-setting>
Syntax
no bandwidth
Mode
Interface Configuration for a VLAN interface.
Example
To set the bandwidth on VLAN2 to be 10 Mbps, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
or
awplus(config-if)#
Related
show running-config
commands
show interface
C613-50631-01 Rev A
Parameter
<bandwidth-setting>
configure terminal
interface vlan2
access-list
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
Sets the bandwidth for the interface. Enter a value in
the range 1 to 10000000000 bits per second. Note that
to avoid entering many zeros, you can add k, m, or g to
internally add 3, 6 or 9 zeros to the number entered. For
example entering 1k is the same as entering 1000.
bandwidth 10000000
bandwidth 10m
1118