Allied Telesis IE340 Series Command Reference Manual page 348

P C C
LUGGABLES AND ABLING OMMANDS
SHOW SYSTEM PLUGGABLE DETAIL
•
NOTE
instead.
Example To display detailed information about the pluggable transceivers installed in a
particular port on the device, use a command like:
awplus#
To display detailed information about all the pluggable transceivers installed on
the device, use the command:
awplus#
Output Figure 8-4:
Table 8-1: Parameters in the output from show system pluggable detail
C613-50631-01 Rev A
Power Monitoring: Displays the received power measurement type, which
can be either OMA (Optical Module Amplitude) or Avg (Average Power)
measured in μW.
: For parameters that are not supported or not specified, a hyphen is displayed
show system pluggable port1.0.1 detail
show system pluggable detail
Example output from show system pluggable detail for a port
awplus#show system pluggable port1.0.1 detail
System Pluggable Information Detail
port1.0.1
==========
Vendor Name:
Device Name:
Device Revision:
Device Type:
Serial Number:
Manufacturing Datecode:
SFP Laser Wavelength:
LinkLength Supported
Single Mode Fiber :
OM1 (62.5um) Fiber:
OM2 (50um) Fiber
OM3 (50um) Fiber
Diagnostic Calibration:
Power Monitoring:
Parameter
Port
Vendor Name
Device Name
Device Revision
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ATI
AT-SPSX
A
1000BASE-SX
A02420N0607J0023
060704
850nm
-
150m
: 300m
: -
External
Average
Description
Specifies the port the pluggable transceiver is installed in.
Specifies the vendor's name for the installed pluggable
transceiver.
Specifies the device name for the installed pluggable
transceiver.
Specifies the hardware revision code for the pluggable
transceiver. This may be useful for troubleshooting because
different devices may support different pluggable
transceiver revisions.
348