Allied Telesis IE340 Series Command Reference Manual page 1003

R C
OUTING OMMANDS
IP ROUTE
Versions of AlliedWare Plus earlier than 5.5.1-2.1 do not support descriptions on
static routes, so a start-up configuration that contains descriptions will be rejected
by these older versions. If you add descriptions, be careful if you downgrade to an
older AlliedWare Plus version.
Examples To add the destination 192.168.3.0 with the mask 255.255.255.0 as a static route
available through the device at 10.10.0.2 with the default administrative distance,
use the commands:
awplus#
awplus(config)#
To remove the destination 192.168.3.0 with the mask 255.255.255.0 as a static
route available through the device at 10.10.0.2 with the default administrative
distance, use the commands:
awplus#
awplus(config)#
To specify a null or blackhole route 192.168.4.0/24, so packets forwarded to this
route are dropped, use the commands:
awplus#
awplus(config)#
To add the destination 192.168.3.0 with the mask 255.255.255.0 as a static route
available through the device at 10.10.0.2 with an administrative distance of 128,
use the commands:
awplus#
awplus(config)#
128
To give a route a description of 'test' when creating it, use the commands:
awplus#
awplus(config)#
test
To remove the description from a route, re-enter the route without specifying the
description parameter:
awplus#
awplus(config)#
Related show ip route
commands
show ip route database
C613-50631-01 Rev A
configure terminal
ip route 192.168.3.0 255.255.255.0 10.10.0.2
configure terminal
no ip route 192.168.3.0 255.255.255.0 10.10.0.2
configure terminal
ip route 192.168.4.0/24 null
configure terminal
ip route 192.168.3.0 255.255.255.0 10.10.0.2
configure terminal
ip route 192.168.3.0/24 10.10.0.2 description
configure terminal
ip route 192.168.3.0/24 10.10.0.2
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
1003