Gvrp Enable (Global) - Allied Telesis IE340 Series Command Reference Manual

GVRP C
OMMANDS
( )
GVRP ENABLE GLOBAL

gvrp enable (global)

Overview Use this command to enable GVRP globally for the switch.
Use the no variant of this command to disable GVRP globally for the switch.
Syntax gvrp enable
no gvrp enable
Mode Global Configuration
Default Disabled by default.
Usage notes Use this command to enable GVRP on the switch. Note that this command does
not enable GVRP on switchports. To enable GVRP on switchports use the
(interface)
enable (global)
You must enable GVRP on both ends of a link for GVRP to propagate VLANs
between links.
NOTE
GVRP and MSTP are mutually exclusive. STP and RSTP are supported by GVRP.
Private VLAN trunk ports are not supported by the current AlliedWare Plus GVRP
implementation. GVRP and private VLAN trunk ports are mutually exclusive.
Examples To enable GVRP for the switch, before enabling GVRP on switchports, enter the
commands:
awplus#
awplus(config)#
To disable GVRP on the switch, which will also disable GVRP enabled on
switchports, enter the commands:
awplus#
awplus(config)#
Validation show gvrp configuration
Commands
Related gvrp (interface)
commands
gvrp dynamic-vlan-creation
C613-50631-01 Rev A
command in Interface Configuration mode. You must issue a
command before issuing a
: MSTP is not supported by the current AlliedWare Plus GVRP implementation.
configure terminal
gvrp enable
configure terminal
no gvrp enable
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
gvrp (interface) command.
gvrp
gvrp
844