Udld Port Aggressive-Mode - Allied Telesis IE340 Series Command Reference Manual

U L D
NIDIRECTIONAL INK ETECTION
-
UDLD PORT AGGRESSIVE MODE

udld port aggressive-mode

Overview Use this command to enable UDLD aggressive mode on an interface.
In normal mode, when the UDLD information times out:
•
•
•
In aggressive mode, when the UDLD information times out:
•
•
Use the no variant of this command to disable aggressive mode on an interface.
udld port aggressive-mode
Syntax
no udld port aggressive-mode
Default Aggressive mode is disabled on an interface by default.
Mode Interface Configuration
Example To change the UDLD mode to aggressive on port1.0.1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To disable aggressive mode on port1.0.1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related udld aggressive-mode
commands
show udld port
C613-50631-01 Rev A
(UDLD) C
OMMANDS
No action is taken by UDLD.
The UDLD port state is set to undetermined.
The port behaves according to its STP state.
UDLD tries to re-establish the state of the port.
If not successful, after 8 retries, the port is disabled.
configure terminal
interface port1.0.1
configure terminal
interface port1.0.1
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
udld port aggressive-mode
no port aggressive-mode
778