Alliedware-Behavior - Allied Telesis IE340 Series Command Reference Manual

RIP C
OMMANDS
-
ALLIEDWARE BEHAVIOR

alliedware-behavior

Overview This command configures your device to exhibit AlliedWare behavior when
sending RIPv1 response/update messages. Configuring for this behavior may be
necessary if you are replacing an AlliedWare device with an AlliedWare Plus device
and wish to ensure consistent RIPv1 behavior.
Use the no variant of this command to implement AlliedWare Plus behavior.
This command has no impact on devices running RIPv2. Reception and
transmission can be independently altered to conform to AlliedWare standard.
alliedware-behavior {rip1-send|rip1-recv}
Syntax
no alliedware-behavior {rip1-send|rip1-recv}
Default By default when sending out RIPv1 updates on an interface, if the prefix (learned
through RIPv2 or otherwise redistributed into RIP) being advertised does not
match the subnetting used on the outgoing RIPv1 interface it will be filtered. The
alliedware-behavior command returns your router's RIPv1 behavior to the
AlliedWare format, where the prefix will be advertised as-is.
For example, if a RIPv1 update is being sent over interface 192.168.1.4/26, by
default the prefix 192.168.1.64/26 will be advertised, but the prefix
192.168.1.144/28 will be filtered because the mask /28 does not match the
interface's mask of /26. If alliedware-behavior rip1-send is configured,
192.168.1.144 would be sent as-is.
Mode Router Configuration
Examples To configure your device for AlliedWare-like behavior when sending and
receiving RIPv1 update messages, enter the commands:
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router)#
C613-50631-01 Rev A
Parameter Description
rip1-send
Configures the router to behave in AlliedWare mode when sending
update messages.
rip1-recv
Configures the router to behave in AlliedWare mode when receiving
update messages.
configure terminal
router rip
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
alliedware-behavior rip1-send
alliedware-behavior rip1-recv
1023