Alarm Facility Input-Alarm Led - Allied Telesis IE340 Series Command Reference Manual

A M C
LARM ONITORING OMMANDS
-
ALARM FACILITY INPUT ALARM LED

alarm facility input-alarm led

Overview Use this command to trigger an alarm if the input contact opens (or if it closes, if
you have used the command
closed).
Use the no variant of this command to remove this alarm.
Syntax alarm facility input-alarm 1 led
no alarm facility input-alarm 1 led
Default By default, there are no alarms
Mode Global Configuration
Usage notes By default, the input alarm will trigger if the input contact opens. You can change
this to closed by using the command
You can also use a relay to trigger an external alarm output, such as a buzzer, by
using the command
Example To make the fault LED flash if the input contact opens, use the commands:
awplus#
awplus(config)#
To make the fault LED flash if the input contact closes, use the commands:
awplus#
awplus(config)#
close
awplus(config)#
To remove that alarm, use the commands:
awplus#
awplus(config)#
Related alarm facility input-alarm alarm-position
commands
alarm facility input-alarm relay
show alarm facility settings
show alarm facility status
C613-50631-01 Rev A
Parameter
input-alarm 1
alarm facility input-alarm
configure terminal
alarm facility input-alarm 1 led
configure terminal
alarm facility input-alarm 1 alarm-position
alarm facility input-alarm 1 led
configure terminal
no alarm facility input-alarm 1 led
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
alarm facility input-alarm alarm-position
Description
The input contact number. These switches have
one input contact, so this must be 1.
alarm facility input-alarm
relay.
to specify
alarm-position.
535