Configuring Radius Accounting - HP ProCurve 6200yl Series Access Security Manual

Note

Configuring RADIUS Accounting

RADIUS Accounting Commands
[no] radius-server host < ip-address >
[acct-port < port-number >]
[key < key-string >]
[no] aaa accounting < exec | network | system >
< start-stop | stop-only> radius
[no] aaa accounting update
periodic < 1 - 525600 > (in minutes)
[no] aaa accounting suppress null-username
show accounting
show accounting sessions
show radius accounting
This section assumes you have already:
■ Configured RADIUS authentication on the switch for one or more
access methods
■ Configured one or more RADIUS servers to support the switch
If you have not already done so, refer to "General RADIUS Setup Procedure"
on page 6-7 before continuing here.
RADIUS accounting collects data about user activity and system events and
sends it to a RADIUS server when specified events occur on the switch, such
as a logoff or a reboot. The switches covered in this guide support three types
of accounting services:
Network accounting: Provides records containing the information
■
listed below on clients directly connected to the switch and operating
under Port-Based Access Control (802.1X):
• Acct-Session-Id
• Acct-Status-Type
• Acct-Terminate-Cause
• Acct-Authentic
• Acct-Delay-Time
• Acct-Input-Packets
RADIUS Authentication and Accounting
Configuring RADIUS Accounting
Page
6-23
6-23
6-23
6-27
6-27
6-27
6-32
6-33
6-33
• Acct-Output-Packets
• Acct-Input-Octets
• Nas-Port
• Acct-Output-Octets
• Acct-Session-Time
• Username
• Service-Type
• NAS-IP-Address
• NAS-Identifier
• Called-Station-Id
6-21