Table of Contents
Advertisement
Step
1.
Enter system view.
2.
Configure a VLAN as an
IPv6 multicast VLAN and
enter its view.
3.
Assign the specified VLANs
to the IPv6 multicast VLAN
as sub-VLANs.
Configuring a port-based IPv6 multicast VLAN
You can assign only Layer 2 Ethernet interfaces or Layer 2 aggregate interfaces as user ports to an
IPv6 multicast VLAN.
Configuration prerequisites
Before you configure a port-based IPv6 multicast VLAN, complete the following tasks:
•
Create VLANs as required.
•
Enable MLD snooping for the VLAN to be configured as the IPv6 multicast VLAN.
•
Enable MLD snooping for all the VLANs that contain the multicast receivers.
Configuring user port attributes
Step
1.
Enter system view.
2.
Enter interface view.
3.
Configure the link type of the
user port as hybrid.
4.
Specify the PVID of the
current user port as the
VLAN to which the user port
belongs.
5.
Configure the current user
port to permit IPv6 multicast
VLAN and to untag the
packets.
Assigning user ports to an IPv6 multicast VLAN
You can assign user ports to an IPv6 multicast VLAN in IPv6 multicast VLAN view or assign a user
port to an IPv6 multicast VLAN in interface view.
Command
system-view
ipv6
multicast-vlan vlan-id
subvlan vlan-list
Command
system-view
interface interface-type
interface-number
port link-type hybrid
port hybrid pvid vlan vlan-id
port hybrid
vlan vlan-id-list untagged
338
Remarks
N/A
By default, a VLAN is not an IPv6
multicast VLAN.
By default, an IPv6 multicast VLAN does
not have any sub-VLANs.
Remarks
N/A
N/A
The default setting is access.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.
By default, the PVID for a hybrid
port is VLAN 1.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.
By default, a hybrid port permits
only VLAN 1.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.
Advertisement
Table of Contents
Troubleshooting
