Port (Ipv6 Multicast Vlan View); Port Multicast-Vlan Ipv6 - HP 6125G Command Reference Manual

port (IPv6 multicast VLAN view)

Syntax
port interface-list
undo port { all | interface-list }
View
IPv6 multicast VLAN view
Default level
2: System level
Parameters
interface-list: Specifies a port in the form of interface-type interface-number, or a port range in the form
of interface-type start-interface-number to interface-type end-interface-number, where the end interface
number must be greater than the start interface number.
all: Specifies all the ports in the current IPv6 multicast VLAN.
Description
Use port to assign the specified ports to the current IPv6 multicast VLAN.
Use undo port to delete the specified ports from the current IPv6 multicast VLAN.
By default, an IPv6 multicast VLAN has no ports.
A port can belong to only one IPv6 multicast VLAN.
You can assign only Ethernet ports, and Layer 2 aggregate interfaces to a multicast VLAN.
Examples
# Assign ports GigabitEthernet 1/0/1 through GigabitEthernet 1/0/5 to IPv6 multicast VLAN 100.
<Sysname> system-view
[Sysname] multicast-vlan ipv6 100
[Sysname-ipv6-mvlan-100] port gigabitethernet 1/0/1 to gigabitethernet 1/0/5

port multicast-vlan ipv6

Syntax
port multicast-vlan ipv6 vlan-id
undo port multicast-vlan ipv6
View
Ethernet interface view, Layer 2 aggregate interface view.
Default level
2: System level
Parameters
vlan-id: Specifies an IPv6 multicast VLAN by its ID, in the range of 1 to 4094.
Description
Use port multicast-vlan ipv6 to assign the current port to the specified IPv6 multicast VLAN.
253