Starting Up Eternity Genx - Matrix Telecom SARVAM UMG System Manual

Hide thumbs Also See for SARVAM UMG:
Table of Contents

Advertisement

Starting Up ETERNITY GENX

Power ON
If you have completed all the installation tasks, switch on power supply.
1.
For PSUNI card installed in the system, connect the three-pin plug of the power cord from the
ETERNITY GENX into the AC outlet, and switch on power supply.
For PS48V card installed in the system, keep the MCB Switch ON and power the FCBC.
Observe the Reset Cycle.
2.
Reset Cycle
Reset Cycle (Power-ON Self Test) takes about 2 minutes to finish.
All the LEDs and the cards of the System are turned on.
Interpreting LEDs
The functioning of the LEDs of the system and the various cards and their meaning are summarized at the
end of the installation instructions for each Card Type.
Refer to the LED Patterns described for each Card Type to verify if the system is operating properly and locate
faults, where they occur.
Matrix SARVAM UMG System Manual
74

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SARVAM UMG and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents