Matrix Telecom SARVAM UMG System Manual page 218

• Set the duration of the First Digit Wait Timer. This is the duration for which you want the system to
wait for the caller to dial the destination number after the dial tone. Valid range is 01 to 99 seconds.
Default: 7 seconds.
• You may configure the following options as End of Dialing indication:
• Set the duration of the Inter Digit Wait Timer. This is the duration for which you want the system to
wait while receiving the digits dialed by the caller to consider it as End of Dialing. You may change
this timer, if required. Valid range is 01 to 99 seconds. Default: 05 seconds.
• In End of Dialing Digit, select # or * as termination digit the system should consider to detect end
of dialing. Default: #
• In Minimum number of digits that can be dialed by the caller, select the minimum number of
digits to be dialed by the user for the system to consider it as a valid number. Valid range is 01 to 24
digits. Default: 2 digits.
• In Maximum Number of digits that can be dialled by the caller, select the maximum number of
digits to be dialed by the user for the system to consider it as End of Dialing. Valid range is 01 to 24
digits. Default: 24 digits.
When the caller dials a number, the system will match it with the above End of Dialing indications
and accept the one that matches first.
• If the caller fails to dial the number during the First Digit Wait Timer, you can either have the system
disconnect the call or route the call to a fixed destination number.
In the If No Digit dialed during First Digit Wait Timer box, select the desired option: Disconnect the
Call or Use Fixed Destination Number. Default: Disconnect Call.
• If you selected Use Fixed Destination Number, enter the desired destination number in the Fixed
Destination Number field. The Destination number may consist of a maximum of 24 digits. Valid
digits are 0 to 9, *, # and . (dot/period). Default: Blank.
• The First Digit Wait Timer is loaded as soon as the system answers the call.
• When you dial the first digit, the First Digit Wait Timer is stopped and the system loads the Inter Digit
Wait Timer.
• SARVAM UMG reloads the Inter Digit Wait Timer:
• each time you dial a new digit till the termination digit is detected.
• when you have dialed the maximum number of digits configured as End of Dialing.
• If you want to enable the feature Making New Call using Access Code on the BRI Port, select the Allow
making New Call using Access Code check box. For further details, see
Access Code".
• Click Submit to save settings.
• If you do not want to route the incoming calls received without CLI, through this BRI Port, select Block
Calls received without CLI on this Port check box.
Matrix SARVAM UMG System Manual
"Making a New Call using
212