Matrix Telecom SARVAM UMG System Manual page 639

• Click the Configuration link.
• By default, Auto Configuration Upgrade check box is enabled. You may clear this check box, if
required.
• In Protocol for Auto Configuration Upgrade, select the protocol used by the Auto Configuration
Server to upgrade the configuration. SARVAM UMG generates file transfer request to the Auto-
Configuration Server according to the protocol you select. You may select TFTP, HTTP or HTTPS.
Default: HTTP.
• In Server Address: Port, enter the IP Address/Domain and the Port of the Auto Configuration Server
on which the configuration files of SARVAM UMG are stored.
The Auto Configuration Server Address can also be obtained by SARVAM UMG using DHCP (using
Option 224). To fetch Auto Configuration Server Address using DHCP, keep the Server Address: Port
field blank.
Make sure that you also set the Connection Type on the
The default Port differs as per the protocol you select. For TFTP, the Default Port is 69. For HTTP, the
Default Port is 80. For HTTPS, the Default Port is 443. You can change the port as per your
requirement. Valid range is 69/ 80/ 443/ 1031 to 65534.
• In Configuration Folder Path, specify the path of the folder on the Auto Configuration Server where
the configuration files are stored. Default: Blank.
• Enable Upgrade Configuration Automatically at Every Power ON check box, if you want SARVAM
UMG to check for updates in the configuration file at each Power ON.
At Power ON, if both Auto Firmware upgrade and Auto Configuration upgrade are enabled, Auto Firmware
upgrade has priority over Auto Configuration upgrade.
633
"Network" page as DHCP.
Matrix SARVAM UMG System Manual