Matrix Telecom SARVAM UMG System Manual page 634

• The protocol to be used: HTTP, HTTPS.
When SARVAM UMG installed at a customer site gets connected to the ITSP network, it will automatically
3.
compare its current firmware with the firmware files stored on the Provisioning Server.
The matrix_firmware.html file helps SARVAM UMG decide which firmware it should upgrade to.
After SARVAM UMG decides the Firmware Version/Revision to upgrade to, it will send the request for the
4.
firmware files to the Provisioning Server. Once the respective firmware files are received, SARVAM UMG
will upgrade its current firmware with the new firmware without the intervention or assistance of a
technician.
The table below describes a few possible cases and the corresponding action taken by SARVAM UMG
Version-Revision of
your SARVAM UMG
V1R5.3.0
To configure Auto Firmware Upgrade parameters,
• Click the Maintenance link to expand.
• Click the Firmware link.
• Select the Auto Firmware Upgrade check box. Default: Disabled.
Matrix SARVAM UMG System Manual
Version- Revision in the
matrix_firmware.html file
received from the
Provisioning Server
V1R4.1.0
V1R5.3.0
V1R4.1.0 and V1R5.3.1
Action Taken by SARVAM UMG
SARVAM UMG will not downgrade its current firmware with
V1R4.1.0
SARVAM UMG will discard the upgrade process as same
Version/Revision is found.
SARVAM UMG will upgrade its current firmware with
V1R5.3.1
.
628