Matrix Telecom SARVAM UMG System Manual page 446

Hide thumbs Also See for SARVAM UMG:

Table of Contents

PRI Settings

If you have selected PRI as Signaling Type, configure the PRI parameters.

Click PRI Settings.

Set the duration of the Overlap Receiving Timer. This timer is relevant while receiving the called party

number information in overlap receiving mode. Valid range is 01 to 99 seconds. Default: 5 seconds.

Select the required option for sending the Caller-Type of Numbering Plan (TON) — Unknown,

International, National, Network Specific, Subscriber, Abbreviated or Reserved. Default: Unknown.

Select the required option for sending the Caller-Numbering Plan Identification (NPI) — Unknown,

ISDN Numbering, Data Numbering, Telex Numbering, National Numbering, Private or Reserved.

Default: ISDN Numbering.

Select the required option for sending the Called-Type of Numbering Plan (TON) — Unknown,

International, National, Network Specific, Subscriber, Abbreviated or Reserved. Default: Unknown.

Select the required option for sending the Called-Numbering Plan Identification (NPI) —Unknown,

ISDN Numbering, Data Numbering, Telex Numbering, National Numbering, Private or Reserved.

Default: ISDN Numbering.

Select the Send Progress Indicator (PI) in SETUP message check box if you want the progress

indicator value to be sent in SETUP message. Default: Disabled.

Matrix SARVAM UMG System Manual

Need help?

Do you have a question about the SARVAM UMG and is the answer not in the manual?