Matrix Telecom SARVAM UMG System Manual page 673

• Configure the System Name. When there are multiple devices connected in the same network, the
name configured helps to identify the SNMP Agent within the network. The System Name can be a
maximum of 40 characters. Default: Blank.
• Configure the System Contact. It is the name and number of the person to be contacted, in case of
notification. The System Contact can be of a maximum of 40 characters. Default: Blank.
• Configure the System Location. This is the physical location of SARVAM UMG. This information is
helpful to the administrator. The System Location may consist of a maximum of 40 characters. Default:
Blank.
• Select the Listen from Specific Manager check box, if you want the system to listen to the incoming
SNMP messages from a specific manager. Default: Disabled.
• If you have enabled Listen from Specific Manager check box, you must configure the specific
Manager's Address.
The Manager's Address can be a Domain Name or an IP Address. It can be a maximum of 64
characters. Default: Blank.
• If SNMP version is set as SNMPv1 or SNMPv2c, configure Community Name.
Community Name identifies the SNMP community in which the sender and recipient of the message
are located. It enables communication between SARVAM UMG and the Manager. The Community
Name can be a maximum of 40 characters. Default: Blank.
• If SNMP version is set as SNMPv3, the System's Engine ID is displayed in this field. This is a unique
identification of the system. It is a hexadecimal field with length of 22 characters.
The ID consists of:
• Enterprise Number (800086df03 which is fixed)
• MAC Address of the system (MAC address of Network port)
Security Settings
• If SNMP version is set as SNMPv3, click Security Settings to expand and configure the following.
• Enter the User Name. The User Name can be a maximum of 40 characters. User Name will be used
for authentication and privacy in SNMPV3.
667 Matrix SARVAM UMG System Manual