Matrix Telecom SARVAM UMG System Manual page 411

In the If No Digit dialed during First Digit Wait Timer box, select the desired option: Disconnect the
Call or Use Fixed Destination Number. Default: Disconnect Call.
• If you selected Use Fixed Destination Number, enter the desired destination number in the Fixed
Destination Number field. The Destination number may consist of a maximum of 24 digits. Valid
digits are 0 to 9, *, # and . (dot/period). Default: Blank.
• The First Digit Wait Timer is loaded as soon as the system answers the call.
• When you dial the first digit, the First Digit Wait Timer is stopped and the system loads the Inter Digit
Wait Timer.
• SARVAM UMG reloads the Inter Digit Wait Timer:
• each time you dial a new digit till the termination digit is detected.
• when you have dialed the maximum number of digits configured as End of Dialing.
• If you want to enable the feature Making New Call using Access Code on the T1E1 Port, select the
Allow making New Call using Access Code check box. For further details, see
using Access
• Click Submit to save settings.
• If you do not want to route the incoming calls received without CLI, through this T1E1 Port, select Block
Calls received without CLI on this Port check box.
• To Route all Incoming calls (without CLI), you may select from any of the following methods:
• to a Fixed Destination Number, see
• on the basis of DDI Number, see
• to the Called Party Number, see
• after Answering the Call and Collecting the Digits, see
the Digits".
Default: to the Called Party Number.
405
Code".
"Route to a Fixed Destination
"Route on the basis of DDI
"Route to the Called Party
Number".
Number".
Number".
"Route after Answering the Call and Collecting
Matrix SARVAM UMG System Manual
"Making a New Call