Table of Contents
Advertisement
•
To enable the feature Disconnect Call using Access Code on the BRI Port, select the Allow Call
Disconnection using Access code check box. To know more about this feature, see
Call using Access Code".
•
Select the required option for sending the Caller- Type of Numbering Plan (TON) — Unknown,
International, National, Network Specific, Subscriber, Abbreviated or Reserved. Default: Unknown.
•
Select the required option for sending the Caller- Numbering Plan Identification (NPI) — Unknown,
ISDN Numbering, Data Numbering, Telex Numbering, National Numbering, Private or Reserved. Default:
ISDN Numbering.
•
Select the required option for sending the Called-Type of Numbering Plan (TON) — Unknown,
International, National, Network Specific, Subscriber, Abbreviated or Reserved. Default: Unknown.
•
Select the required option for sending the Called-Numbering Plan Identification (NPI) —Unknown, ISDN
Numbering, Data Numbering, Telex Numbering, National Numbering, Private or Reserved. Default: ISDN
Numbering.
•
Select the Send Progress Indicator (PI) in SETUP message check box if you want the progress
indicator value to be sent in SETUP message. Default: Disabled.
•
Set the Progress Indicator (PI) value in SETUP message to the desired value. You can select — 1 or 3.
Progress indicator 1 indicates that the call is not end-to-end ISDN and further call progress information
may be available in-band.
Progress indicator 3 indicates that the origination address is non-ISDN. This value will be included in the
Setup Message to indicate whether the calling party is an ISDN device or not. Default: 1.
•
Select the Progress Indicator (PI) Location for the SETUP message.The location is a progress indicator
information element that indicates from where the message is coming. Default: Public Network serving the
local user.
•
Select the Send Presentation Indicator and Screening Indicator check box, if you want the system to
display the presentation and screening information to the remote end. Default: Disabled.
•
Select the required Presentation Indicator. This allows remote end to know whether CLI Number
should be displayed to user or not. You can select — Presentation Allowed, Presentation Restricted or
Received from Source Port. Default: Received from Source Port.
•
Select the required Screening Indicator. This indicates whether the information is provided by the
user or the network along with the screening details — not screened, verified and passed or verified
and failed. Default: User-provided, not screened.
•
Select the Bearer Service supported by your service provider. This will be sent in the SETUP Message.
You can select — Speech, 3.1 KHz Audio. Default: Speech
•
Select the Progress Tone on Disconnect check box, if you want the system to play the progress tone on
the port when the call is released by the remote end or disconnected by the system. Default: Enabled.
•
Select the Send SETUP_ACK with PI check box, if you want the system to send PI (Progress indicator)
element in Setup Ack message. Default: Enabled.
Matrix SARVAM UMG System Manual
"Disconnecting a
246
Advertisement
Table of Contents
Need help?
Do you have a question about the SARVAM UMG and is the answer not in the manual?