Matrix Telecom SARVAM UMG System Manual page 675

Notification Settings
• Click Notification Settings to expand.
If SNMP version is set as SNMPv1, configure the following parameters.
• If you want SARVAM UMG to generate Trap message for an error, select the Trap check box to
enable. Default: Disabled.
• You must configure the Notification Destination. SARVAM UMG will send the notification (error
message) to the destination configured.
The Notification Destination can be an IP Address or a Domain Name and the Port of the Manager
or of any other device where you want to receive the trap messages. IP Address/Domain Name can
be a maximum of 64 characters. Valid range is 0 to 65535. Default: 162.
• Click Submit button to save the settings.
If SNMP version is set as SNMPv2c or SNMPv3, configure the following parameters.
• Select the Notification check box to enable, if you want SARVAM UMG to generate Trap or Inform
message for an error.
• Select the Notification Type. You may select Trap or Inform.
If you want the system to send notification message without acknowledgement, select Trap.
If you want the system to send notification message with acknowledgement, select Inform.
• If you select Inform as the Notification Type, you must configure Retry Attempts and Retry Interval.
If acknowledgement is not received from the Manager for the notification sent, the system will keep
retransmitting the message for the number of attempts you have configured as the Retry Attempts.
Default: 3.
669 Matrix SARVAM UMG System Manual