Table of Contents
Advertisement
•
Select the Play Routing Tone check box, if you want the system to play routing tone while routing the
call to the destination port. During an outgoing call, the routing tone indicates that the call is in
progress. Default: Disabled.
•
Select the Call Release Timer check box, if you want the system to release the ports involved in a call
after a definite time period. Default: Enabled.
This timer is loaded when a call gets matured and stops whenever a port involved in a call is released.
•
Set the duration of the Release Timer. Valid range is 001 to 999 minutes. Default: 999 minutes.
•
Set the duration of the Routing Group Busy Wait Timer. This timer defines the duration for which you
want SARVAM UMG to search for a free destination port in the Routing Group and the Fallback
Routing Group in order to route and place the call. This timer is loaded when no destination port is free
in both the Routing Group and the Fallback Routing Group. Valid range is 1 to 99 seconds. Default: 1
second.
•
Set the duration of the Transfer Notification Timer. This timer defines the duration for which you want
SARVAM UMG to wait for the notification regarding the status of the transferred call. It notifies whether
the transfer target is busy, the call has been answered or the call has been disconnected etc.
This timer is loaded when a user performs a transfer activity. The user (transferor) is notified of the
status of the transfer activity within the time period you have set for this timer.
Valid range is 1 to 999 seconds. Default: 60 seconds.
•
Set the duration of the Ring Timer. This timer defines the duration for which you want SARVAM UMG
to play a ring on the FXS Port to indicate the incoming call. This timer is loaded when the call is placed
on the FXS Port, that is, either there is a ring event on the FXS Port or call waiting beeps are played
when the FXS Port is busy. Valid range is 1 to 99 seconds. Default: 45 seconds.
•
Set the duration of the Error Tone Timer. This timer defines the duration for which you want SARVAM
UMG to will play the Error Tone. Valid range is 0 to 9 seconds. Default: 7 seconds.
•
Set the duration of the Error Tone Delay Timer. This timer defines the duration for which you want
SARVAM UMG to play the Error Tone whenever a call is disconnected during speech. Valid range is 00
to 99 seconds. Default: 0 seconds.
•
Set the duration of the Unconnected Calls Record Delete Timer. This timer defines the duration for
which you want SARVAM UMG to route those calls which have been returned unconnected from —
BRI (Terminal) Port, T1E1 Port (T1 line), Mobile Port or SIP Trunk. These calls are routed back to the
original callers. Default: 999 minutes.
This timer will work only if you have enabled the Route calls returned unconnected to Original
Caller check box under Handling of Outgoing Calls in the BRI (Terminal) Port, T1E1 Port (Terminal
line), Mobile Port or the SIP Trunk.
This timer is used whenever an outgoing call made using the port on which this feature is enabled is
either found busy or unanswered. SARVAM UMG stores the numbers of the Calling Party, Called Party
and the source port through which the outgoing calls were made.
465
Matrix SARVAM UMG System Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the SARVAM UMG and is the answer not in the manual?