Matrix Telecom SARVAM UMG System Manual page 139

Route After Answering the Call and Collecting the Digits
In this method, the system answers the incoming call on the FXO Port and plays dial tone to the caller, allowing the
caller to dial the desired number. The number dialed by the caller is considered as the destination number.
To apply this method, do the following:
• In Route all incoming calls (with CLI), select after Answering the Call and Collecting the Digits.
The related parameters appear under Answering the Call and Collecting the Digits.
• If you want to enable PIN Authentication on the FXO Port, select the Prompt caller to enter PIN check
box.
If you enable this check box, you must also configure the PIN Authentication Table. To know more
about this feature and for detail instructions, see
133
"PIN Authentication" under Advanced Settings.
Matrix SARVAM UMG System Manual