Matrix Telecom SARVAM UMG System Manual page 311

Route after Answering the Call and Collecting the Digits
In this method, the incoming call is answered and dial tone is played to the caller, allowing the caller to dial the
desired number. The number dialed by the caller is considered as the destination number.
To apply this method, do the following:
• In Route all Incoming calls (with CLI), select after Answering the Call and Collecting the Digits.
The related parameters of this method appear under Answering the call and collecting the digits.
• If you want to enable PIN Authentication on the SIP Trunk, select the Prompt caller to enter PIN
check box.
If you enable this check box, you must also configure the PIN Authentication Table. To know more
about this feature and for detailed instructions, see
• SARVAM UMG supports 8 Dial Plans with total 64 entries in each table. When a user dials a number, it
is compared with the Destination Number configured in the Dial Plan. If a match is found, the system
routes the call immediately without waiting for End of Dialing and if a match is not found, the system will
wait for the End of Dialing and then route the call as per the Destination Port Selection method
configured.
305
"PIN Authentication" under Advanced Settings.
Matrix SARVAM UMG System Manual