Matrix Telecom SARVAM UMG System Manual page 313

Hide thumbs Also See for SARVAM UMG:
Table of Contents

Advertisement

If you want to enable the feature Making New Call using Access Code on the SIP Trunk, select the
Allow making New Call using Access Code check box. For further details, see
using Access
Click Submit to save settings.
If you do not want to route the incoming calls received without CLI, through this SIP Trunk, select Block
Calls received without CLI on this SIP Trunk check box.
To Route all Incoming calls (without CLI), you may select from any of the following methods:
to a Fixed Destination Number, see
on the basis of DDI Number, see
to the Called Party Number, see
after Answering the Call and Collecting the Digits, see
the
Digits".
Default: to the Called Party Number.
Destination Port Determination
For the SIP Trunk, select the Destination Port for routing calls from the following options:
Fixed
On the basis of Destination Number
On the basis of Calling Party Number
Default: Fixed.
Read the description and follow the instructions for each of these destination port selection methods given
below.
If the destination number to be dialed out is an IP Address, SARVAM UMG will not check the Destination
Port Determination Method. Instead, it will route the call using the SIP Trunk / Group programmed for IP
Dialing. (To know more, see the feature description
307
Code".
"Route to a Fixed Destination
"Route on the basis of DDI
"Route to the Called Party
Number".
Number".
Number".
"Route after Answering the Call and Collecting
"IP
Dialing").
Matrix SARVAM UMG System Manual
"Making a New Call

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SARVAM UMG and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents