Bri Port - Network - Matrix Telecom SARVAM UMG System Manual

BRI Port - Network

SARVAM UMG supports BRI Ports to which terminal equipments — ISDN Phone, Video Conferencing Unit or a
Dialogic Card— can be connected. You must configure the Orientation of the BRI Port as Network.
• Click the Basic Settings link to expand.
• Click the BRI Port link.
The BRI Port page displays the following parameters:
• Port: It displays the BRI Port numbers. Click on the desired BRI Port number to configure the Port
Parameters.
• Hardware Slot-Port: The SARVAM UMG can automatically detect and assign the Hardware Slot and Port
numbers to the BRI software ports. However, if required you may change the Hardware Slot and Port
assigned to the BRI software port. In this case, enter the desired Hardware Slot and Port number.
• Enable: Keep the BRI Ports enabled. Clear the BRI Port Enable check box, only if you do not want to use
the respective port. Default: Enabled.
• Name: Assign a Name to the BRI Port for identification. The Name can be a maximum of 24 characters.
• Status: This displays the status of Layer 1 and Layer 2, that is, Up or Down.
• Interface Type: It displays the type of interface you select — Point to Point or Point to Multipoint.
• Orientation: It displays the type of orientation you select — Network or Terminal.
• Call Routing: It displays the Call Routing Method you select.
To configure the BRI Port as Network,
• Click BRI-1.
Matrix SARVAM UMG System Manual 164