Matrix Telecom SARVAM UMG System Manual page 54

Plug in the RJ45 end of the Trunk Card cables into the respective connectors. Refer to the connector
7.
diagrams illustrated above for each CO Card type.
Terminate the free end of the CO Card cable into the punch down blocks of the Krone modules designated
8.
for 'Trunk Lines' on
Trunk cables from the ETERNITYGENX are to be connected with the Trunk Lines from the PSTN/CO
terminated on the MDF. Each wire-pair from the ETERNITY GENX CO Port must be terminated on the
bottom of the Krone Connector, while the wire-pair of the trunk line from the CO Network to be connected
to this port must be terminated on the top of the Krone Connector.
Refer the topics
the MDF".
Repeat these steps to install other CO cards, if applicable.
9.
Matrix SARVAM UMG System Manual
"The Main Distribution Frame
"The Main Distribution Frame (MDF)"
(MDF)".
and "Terminating Trunk and Extension Cables on
48