Bri Port - Terminal - Matrix Telecom SARVAM UMG System Manual

BRI Port - Terminal

If you have connected the BRI line from your ISDN Service Provider directly to BRI Port of the SARVAM UMG over
the NT1 device or connected the BRI Port to an ISDN System (NT), you must configure the Orientation Type of
the port as Terminal.
• Click the Basic Settings link to expand.
• Click the BRI Port link.
The BRI Port page displays the following parameters:
• Port: It displays the BRI Port numbers.Click on the desired BRI Port number to configure the Port
Parameters.
• Hardware Slot-Port: The SARVAM UMG can automatically detect and assign the Hardware Slot and Port
numbers to the BRI software ports. However, if required you may change the Hardware Slot and Port
assigned to the BRI software port. In this case, enter the desired Hardware Slot and Port number.
• Enable: Keep the BRI Ports enabled. Clear the BRI Port Enable check box, only if you do not want to use
the respective port. Default: Enabled.
• Name: Assign a Name to the BRI Port for identification. The Name can be a maximum of 24 characters.
• Status: This displays the status of Layer 1 and Layer 2, that is, Up or Down.
• Interface Type: It displays the type of interface you select — Point to Point or Point to Multipoint.
• Orientation: It displays the type of orientation you select — Network or Terminal.
• Call Routing: It displays the Call Routing Method you select.
Matrix SARVAM UMG System Manual 200