Siemens SINUMERIK 840Di Diagnostic Manual page 94

Overview of Alarms
NCK alarms
8082 A wrong license key was entered three times, Power On required before
next try.
Definitions: The license key was entered wrongly at least three times. Before the next input, a new power ON is
required.
Reaction: Alarm display.
Remedy: Execute NCK Power On and enter the license key (correctly).
Program Clear alarm with the Delete key or NC START.
Continuation:
8088 'Selection of non-grinding-specific tools' option not possible
Definitions: The system version of the software only allows selection of grinding specific tools (i.e. tools of type
4xx).
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select a tool of type 4xx (grinding tool)
or install a standard version of the system software
Program Clear alarm with the RESET key. Restart part program
Continuation:
8098 Invalid combination of options (%1)
Parameters: %1 = Bit mask of options
Definitions: The following restrictions apply to this module for the combination of options:
The option "Two-channel" and the options "External language", "Nibbling", "Neural quadrant error
compensation" and "Measurement level 2" exclude one another!
Bit0 (LSB): Nibbling
Bit1 : External language
Bit2 : Neural quadrant error compensation
Bit3 : Measurement level 2
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Set the options accordingly.
Program Switch control OFF - ON.
Continuation:
2-94
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006