Siemens SINUMERIK 840Di Diagnostic Manual page 624

Overview of Alarms
HMI alarms
101153 Erroneous HMI NCK communication %1 %2
Parameters: %1 = Error class
%2 = Error code
Definitions: In the start-up area the softkey "Calculate controller data", for example, was pressed.
An unspecific error message is sent from the NCK or drive as acknowledgement for this function call.
By using the two hexadecimal values (error class, error code), the start-up engineer can perform an
error diagnostics.
Remedy: --
101154 PI service refused
Definitions: The current status of the NKC/drive does not permit the function that was selected.
Remedy: See the Installation and Start-up Guide.
101155 Path %1 does not exist
Parameters: %1 = Path
Definitions: During a file function, e.g.saving boot files, an attempt was made to access
a non-existent path.
Remedy: Switch the control OFF/ON or see the Installation and Start-up Guide.
101156 Function impermissible
Definitions: The selected function is impermissible.
Remedy: See the Installation and Start-up Guide.
101157 File %1 does not exist
Parameters: %1 = File name
Definitions: In the start-up area the softkey "delete boot files", for example, was pressed, although no boot files
are yet available.
Remedy: --
101158 Function in current operating mode not allowed
Definitions: The drive's current status does not permit this function.
Remedy: --
101159 Remote block in incorrect state
Definitions: The drive's current status does not permit this function.
Remedy: --
101160 Date and time of PLC set
Definitions: In the PLC status, the time or date was changed.
Remedy: --
101161 The drive is not in cyclic mode!
Definitions: The start-up is not completely carried out, therefore, the function "Calculate motor data" cannot be
selected.
Remedy: --
101162 MDx134/MDx400
MOTOR_NOMINAL_FREQUENCY/MOTOR_RATED_SPEED illeg.
Definitions: --
Remedy: --
2-624
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006