Siemens SINUMERIK 840Di Diagnostic Manual page 195

11/2006
14013 Channel %1 block %2 number of subroutine passes invalid
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In a subroutine call the programmed number of passes P is zero or negative.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Program number of passes between 1 and 9 999.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14014 Channel %1 selected program %3 not available or will be edited
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Program name
Definitions: The selected parts program is not in the NCK memory or the access authorization for the program
selection is from a higher level than the current control status.
During creation, this program received the protection level of the NC control which was active at the
time.
In SW 5 or higher a program edited on HMI can no longer be started with NC Start.
The alarm will also be issued, if a file other than the specified definition file has been selected for the
GUD or macro definition.
Reaction: Alarm display.
Remedy: Reload the program in the NCK memory or check and correct the name of the directory (workpiece
overview) and the program (program overview) and reselect.
Program Clear alarm with the Delete key or NC START.
Continuation:
14015 Channel %1 block %2 program %3 is not enabled
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Program name
Definitions: The execution right currently set in the control (e.g. key switch position 0) is inadequate to execute
part program %3.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: - Raise the execution right to match the protection level of part program %3
- Assign a lower protection level to part program %3 or release (key switch protection level 0)
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-195