Siemens SINUMERIK 840Di Diagnostic Manual page 531

11/2006
61273 Channel %1 block %2: Insertion depth too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Insertion depth on chamfering too large.
Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Decrease the insertion depth.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61274 Channel %1 block %2: Invalid tool angle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Invalid tool angle.
Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check tool angle.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61275 Channel %1 block %2: Target point violates software limit switch!
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Due to a swivel action, the end point is outside the software limit switches.
Alarm triggered by following cycle: E_SP_RP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select another retraction plane or approach a suitable interpolation point.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61276 Channel %1 block %2: External tool diameter required for restrictions
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Outer tool diameter required in case of delimitations.
Alarm triggered by following cycle: CYCLE61.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Specify the outer tool diameter.
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-531