Siemens SINUMERIK 840Di Diagnostic Manual page 256

Overview of Alarms
NCK alarms
14782 Channel %1 block %2 non-active function used (identification %3)
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Fine ID
Definitions: A non-active function is used in the block
Brief description of the identification
1 Transformation
2 H number of the tool
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: - Modify part program.
- Activate function.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14783 Channel %1 block %2 coordinate system-specific working area limitation
is not active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An attempt is made in the block to activate a group of the coordinate system-specific working area
limitation.
However, this group is not set up (see machine data $MC_MM_NUM_WORKAREA_CS_GROUPS).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
The NC program is stopped. The G code of the group WALCS01 - WALCS10 can be changed.
Remedy: - Modify part programm.
- Activate more coordinate system-specific working area limitations.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14790 Channel %1 block %2 axis %3 programmed by PLC
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis
Definitions: In the NC block, an axis has been programmed that is already being traversed by the PLC.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: - Modify part program, do not use this axis.
- Stop traversing motion of the axis by the PLC, modify part program (insert WAITP).
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
2-256
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006