Siemens SINUMERIK 840Di Diagnostic Manual page 520

Overview of Alarms
NCK alarms
61231 Channel %1 block %2: ShopMill program %4 not executable, as not
tested by ShopMill
Parameters: %1 = Channel number
%2 = Block number, label
%4 = Program name
Definitions: Before a ShopMill program can be executed, it has to be tested by ShopMill.
Alarm triggered by following cycle: E_HEAD.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: The program has to be simulated first in ShopMill or loaded into the operating mode "Machine auto"
by ShopMill.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61232 Channel %1 block %2: Impossible to load magazine tool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Only manual tools may be loaded into a swivel head in which only manual tools can be loaded.
The alarm is triggered by the following cycles: E_TD, E_TFS, F_TFS
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Load a manual tool into the swivel head or set the parameter "Tool change" in the start-up screen form
"Rotary axes" to "Automatic".
Program Clear alarm with the RESET key. Restart part program
Continuation:
61233 Channel %1 block %2: Thread angle wrongly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The thread angles were specified too large or too small.
Alarm triggered by following cycles: E_TR_CON, F_TR_CON
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check thread geometry.
Program Clear alarm with the RESET key. Restart part program
Continuation:
2-520
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006