Siemens SINUMERIK 840Di Diagnostic Manual page 149

11/2006
10944 Channel %1 block %2 curve table %3: illegal transformation
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Number of curve table
Definitions: It is impermissible to use a transformation in a curve table if the leading axis or following axis
programmed in CTABDEF is involved in the transformation. Exception: TRAANG.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Correct NC part program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10945 Channel %1 block %2 curve table %3: illegal coupling of axes
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Number of curve table
Definitions: It is not possible to program axis links for the leading axes and following axis programmed in
CTABDEF.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Correct NC part program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10946 Channel %1 block %2 curve table %3: no contour defined
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Number of curve table
Definitions: No movement for the leading axis was programmed between CTABDEF and CTABEND. A curve
table is not permitted without a contour.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Correct the part program and start it again.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10947 Channel %1 block %2 curve table %3: contour not continuous
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Number of curve table
Definitions: The contour in a curve table must be continuous. Incontinuity can occur, for example, as a result of
activating a transformation.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Correct the part program and start it again.
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-149