Siemens SINUMERIK 840Di Diagnostic Manual page 851

11/2006
No. 115
Explanation The event is triggered by the positive PLC edge of the "Repos-Mode-Edge"signal.
Cause The channel is active (program running, block search, loading machine data)
Remedy Abort the program with the Reset key or stop the program (not with block search, loading
machine data).
No. 116
Explanation Activate tool-management commands (Ch. VDI signal).
Cause The NCK channel is in a state other than "ready".
Remedy Abort the program or process with the Reset key or wait for end of program.
No. 117
Explanation Deactivate tool-management commands (Ch. VDI signal).
Cause The NCK channel is in a state other than "ready".
Remedy Abort the program or process with the Reset key or wait for end of program.
No. 118
Explanation Selection of desired safety limitations (SGE) (always allowed).
Cause -
Remedy -
No. 119
Explanation Stop run, i.e., the NCK has automatically stopped at an OPI-defined block
Cause 1. SFC is not in automatic mode
Remedy -
No. 120
Explanation Rapid lift with a single axis
Cause The axis is not controlled by the PLC
Remedy -
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), Edition 11/2006
List of Action Numbers
3-851