Siemens SINUMERIK 840Di Diagnostic Manual page 550

Overview of Alarms
NCK alarms
61423 Channel %1 block %2: Parameter _TNUM not agreed or not created
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following measuring cycles: CYCLE996
Remedy: Causes of error:
1. Parameter CYCLE996 _TNUM incorrect or equals zero
2. No swivel data record created -> MD18088 = 0
61424 Channel %1 block %2: Parameter _SETVAL for diameter of calibration
ball incorrect
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following measuring cycles: CYCLE996
Remedy: Check parameter _SETVAL.
61425 Channel %1 block %2: Parameter for measuring axis rotary axis 1 or 2
incorrect -> Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following measuring cycles: CYCLE996
Remedy: Causes of error:
1. Error code = A
2. Error code = B
3. Error code = C
4. Error code = D
5. Error code = E
61426 Channel %1 block %2: Sum of the active offsets does not equal zero ->
Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following measuring cycles: CYCLE996
Remedy: Causes of error:
Check the overview of active offsets ($P_ACTFRAME)
1. Error code = A
2. Error code = B
3. Error code = C
4. Error code = D
5. Error code = E
61427 Channel %1 block %2: Tool data of the active workpiece probe incorrect
or inactive --> Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following measuring cycles: CYCLE996
Remedy: Causes of error:
1. Error code = A
2. Error code = B
2-550
-> Rotary axis number incorrect (1 or 2)
-> No name agreed for rotary axis 1
-> Rotary axis vector 1 equals zero
-> No name agreed for rotary axis 2
-> Rotary axis vector 2 equals zero
-> Sum of the translatory offsets of the geometry axes <> 0
-> Sum of the fine offsets of the geometry axes <> 0
-> Sum of the rotary components of the geometry axes <> 0
-> Sum of the translatory offsets of rotary axis 1 <> 0
-> Sum of the translatory offsets of rotary axis 2 <> 0
-> Workpiece probe (or tool edge) inactive
-> Length L1 of the workpiece probe = 0
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
© Siemens AG, 2006. All rights reserved
11/2006