Siemens SINUMERIK 840Di Diagnostic Manual page 510

Overview of Alarms
NCK alarms
61182 Channel %1 block %2: Name of swivel data record unknown
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: the specified name of the swivel data block is unknown. Alarm triggered by following cycles:
CYCLE800.
Remedy: Check the name of the swivel data block.
61183 Channel %1 block %2: Clearance mode _FR outside of value range 0..2.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The retraction mode value lies outside of the valid range. Alarm triggered by following cycles:
CYCLE800.
Remedy: Check installation and start-up of swivel cycle CYCLE800 -> retraction
parameter _FR.
61184 Channel %1 block %2: No solution possible with current input angle
values
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The surface defined via the input angle cannot be processed with the machine. Alarm triggered by
following cycles: CYCLE800.
Remedy: -Check the angle entered for the swiveling of the machining plane.
-Parameter _MODE coding incorrect, e.g. rotation axis-wise YXY
61185 Channel %1 block %2: no or wrong (min > max) angle areas of rotary
axes agreed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The rotary axis angle range is invalild. Alarm triggered by following cycles: CYCLE800.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check installation and start-up of the swivel cycle CYCLE800.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61186 Channel %1 block %2: Invalid rotary axis vectors --> Start-up check
swivel cycle CYCLE800
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No or incorrect entry for rotary axis vector V1 or V2. Alarm triggered by following cycles: CYCLE800.
Remedy: Check installation and start-up of the swivel cycle CYCLE800.
Check rotary axis vectors V1 and V2.
2-510
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006