Siemens SINUMERIK 840Di Diagnostic Manual page 545
Hide thumbs
Also See for SINUMERIK 840Di:
- Function manual (2050 pages) ,
- Manual (552 pages) ,
- System overview (55 pages)
Table of Contents
Advertisement
11/2006
61363
Channel %1 Block %2: Max. no. of value lines for recording exceeded
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
Maximum number of value lines exceeded.
Alarm triggerd by following cycle: CYCLE105.
Remedy:
Reduce the number of value lines.
Check parameter _PROTFORM[4].
61364
Channel %1 block %2: Check distance from measuring point 1 to
measuring point2
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm is triggerd by the following cycles: CYCLE998.
Parameter _ID is <= 0.
Remedy:
Check parameter _ID.
61365
Channel %1 block %2: Check circular feed
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm is triggerd by the following cycles: CYCLE979.
Parameter _RF is <= 0.
Remedy:
Check parameter _RF.
61366
Channel %1 block %2: Direction of rotation for tool measurement with
rotating spindle not specified in _CM[5]
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm is triggerd by the following cycles: CYCLE971.
Permissible values for data field _CM[5] in GUD6 block are 3 (corresponds to M3) or 4 (corresponds
to M4).
Remedy:
Check parameter _CM[5] in GUD6.
61367
Channel %1 block %2: Parameters _SETV[0...3] or _SETV[4...7] are
identical
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm is triggerd by the following cycles: CYCLE961.
Remedy:
Specify different positions for the relevant points of _SETV[0...7] .
61368
Channel %1 block %2: Straights through parameter _SETV[0...3] or
_SETV[4...7]do not intersect
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm is triggerd by the following cycles: CYCLE961.
Remedy:
Specify different positions for the relevant points of _SETV[0...7] .
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-545
Hide quick links:
Advertisement
Table of Contents
