Siemens SINUMERIK 840Di Diagnostic Manual page 492

Overview of Alarms
NCK alarms
61000 Channel %1 block %2: No tool offset active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: LONGHOLE, SLOT1, SLOT2, POCKET1 through POCKET4,
CYCLE71, CYCLE72, CYCLE90, CYCLE93 through CYCLE96.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: D-correction must be programmed prior to cycle call.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61001 Channel %1 block %2: Thread lead incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840, CYCLE96, CYCLE97.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Check parameter for the thread size or setting for the lead (contradict each other).
Program Clear alarm with the RESET key. Restart part program
Continuation:
61002 Channel %1 block %2: Type of machining incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The value of the VARI parameter for the machining has been incorrectly specified. Alarm triggered by
following cycles: SLOT1, SLOT2, POCKET1 to POCKET4, CYCLE71, CYCLE72, CYCLE76,
CYCLE77, CYCLE93, CYCLE95, CYCLE97, CYCLE98.
Remedy: Modify VARI parameter.
61003 Channel %1 Block %2: No feed programmed in cycle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parameter for the feed has been incorrectly specified. Alarm triggered by following cycles:
CYCLE71, CYCLE72.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Modify feed parameter.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61004 Channel %1 Block %2: Incorrect configuration of geometry axes
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The geometry-axes sequence is wrong. CYCLE328
Reaction: Alarm display.
Remedy: --
Program Internal
Continuation:
2-492
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006