Siemens SINUMERIK 840Di Diagnostic Manual page 101

11/2006
10232 [up to SW 3.x only] Mode group %2 channel %1 does not permit mode
change
Parameters: %1 = Channel number
%2 = Mode group number
Definitions: The change to the desired mode is not permitted. You can only perform the mode change in the "reset"
state.
Reaction: Alarm display.
Remedy: You can change the mode by pressing the Reset key and repeating the mode change.
Program Clear alarm with the Delete key or NC START.
Continuation:
10240 [up to SW 3.x only] Mode group %2 channel %1 mode change not
possible
Parameters: %1 = Channel number
%2 = Mode group number
Definitions: The mode change would cause the "reorganization" of the preprocessor buffer. This is not possible at
present, because a complex geometry section is being processed.
Reaction: Alarm display.
Remedy: You can change the mode by pressing the Reset key and repeating the mode change.
Program Clear alarm with the Delete key or NC START.
Continuation:
10241 [up to SW 3.x only] Mode group %2 mode change in active channel %1
not possible
Parameters: %1 = Channel number
%2 = Mode group number
Definitions: The channel is not in the stopped state. Reorganization is therefore impossible.
Reaction: Alarm display.
Remedy: Press NC Stop and perform the action again.
Program Clear alarm with the Delete key or NC START.
Continuation:
10242 [up to SW 3.x only] Mode group %2 mode change in channel %1 not
possible at this time
Parameters: %1 = Channel number
%2 = Mode group number
Definitions: The internal state of the indicated channel is not uniquely defined (e.g. in initialization mode or waiting
for an acknowledgement from the sequence control system).
Reaction: Alarm display.
Remedy: You can change the mode by pressing the Reset key and repeating the mode selection.
Program Clear alarm with the Delete key or NC START.
Continuation:
10243 [up to SW 3.x only] Channel %1: mode group %2 cannot change mode
Parameters: %1 = Channel number
%2 = Mode group number
Definitions: The requested mode change cannot be executed because NC functions are still running in the other
channel, e.g. part program execution.
Reaction: Alarm display.
Remedy: You can change the mode by pressing the Reset key and repeating the mode selection.
Program Clear alarm with the Delete key or NC START.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-101