Siemens SINUMERIK 840Di Diagnostic Manual page 179

11/2006
12555 Channel %1 block %2 function not available (identification %3)
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Fine ID
Definitions: The identifier has not been defined for this system
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Press the NC stop key and select the "Compensation block" function by pressing the "Program
correct" softkey. The correction indicator will position in the incorrect block.
- Correct the name used (write error)
- Use a better software system in case of malfunction
- Check the definition of variables, subroutines and macros
- Declare a subroutine with EXTERNAL; load the subroutine to SPF-Dir
- Check the interface definition of the subroutine
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12556 Channel %1 block %2 name %3 Name is already known
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source symbol
Definitions: The name of the symbol created is part of the
NC language scope and therefore already known. Although the NC function
is not active, this name can no longer be used for GUDs, macros
and PROC definitions.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Press key NC Stop and select "Correction block" function by pressing softkey "Program correct". The
correction indicator is set to the incorrect block.
- Correct the name used (typing error)
- With machine data $MN_NC_LANGUAGE_CONFIGURATION = 2 or 4, only those language
commands are created, the option of which has been set
or the function of which is active.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-179