Siemens SINUMERIK 840Di Diagnostic Manual page 503

11/2006
61121 Channel %1 Block %2: Number of teeth per cutting edge is missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No value was entered for the number of teeth per cutting edge. Alarm triggered by following cycles:
CYCLE70.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter the number of teeth/cutting edges for the active tool into the tool list.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61122 Channel %1 Block %2: Safety distance incorrectly defined in plane
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The safety clearance is negative or zero. This is not allowed.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Define the safety clearance.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61123 Channel %1 Block %2: CYCLE72 cannot be simulated
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE72.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Clear alarm with the RESET key. Restart part program
Continuation:
61124 Channel %1 Block %2: Infeed width is not programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE71.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: With active simulation without tool, a value for the infeed width _MIDA must always be programmed.
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-503