Siemens SINUMERIK 840Di Diagnostic Manual page 249

11/2006
14753 Channel %1 block %2 motion synchronous actions with illegal
interpolation type
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The active interpolation type (e.g. 5-axis interpolation) is not allowed for the motion synchronous
action or for the function "Several feeds".
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14754 Channel %1 block %2 motion synchronous actions and wrong feed type
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The active feed type is not allowed for the motion synchronous action or for the function "Several
feeds".
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14755 Channel %1 block %2 motion synchronous actions without traverse
motion
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed motion synchronous action and the function "Several feeds" require a traversing
motion or the value of the traversing motion is 0.
This alarm is no longer used after P3.2.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14756 Channel %1 block %2 motion synchronous action and wrong value
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Value of the synchronous action or the function "Several feeds" is not allowed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program. Check whether a negative value was entered for a synchronous action.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-249