Siemens SINUMERIK 840Di Diagnostic Manual page 73

11/2006
6411 Channel %1 tool %2 has reached its prewarning limit with D = %4
Parameters: %1 = Channel number
%2 = Tool identifier (name)
%3 = -Not used-
%4 = D number
Definitions: Tool monitoring: This message informs that the specified D offset has reached its prewarning limit for
a time-, quantity- or wear-monitored tool. If possible, the D number is displayed; if not, value 0 is
assigned to the 4th parameter.
If the function additive offset is being used, additive offset monitoring may be active instead of tool
wear monitoring. The actual type of tool monitoring is a tool property (see $TC_TP9).
If replacement tools are not being used, the duplo number specified has no meaning.
The alarm originates during NC program execution.
Reaction: Interface signals are set.
Alarm display.
Remedy: For information only. The user must decide what to do.
Program Clear alarm with the Delete key or NC START.
Continuation:
6412 TO unit %1 tool %2 has reached its monitoring limit with D = %4
Parameters: %1 = TO unit
%2 = Tool identifier (name)
%3 = -Not used-
%4 = D number
Definitions: Tool monitoring: This message informs that the specified D offset has reached its prewarning limit for
a time-, quantity- or wear-monitored tool. If possible, the D number is displayed; if not, value 0 is
assigned to the 4th parameter.
If the function additive offset is being used, additive offset monitoring may be active instead of tool
wear monitoring.
The actual type of tool monitoring is a tool property (see $TC_TP9).
If replacement tools are not being used, the duplo number specified has no meaning.
The alarm is triggered through the MMC or PLC (=OPI interface). The channel context is not defined.
The TO unit was specified for this reason (see $MC_MM_LINK_TOA_UNIT).
Reaction: Interface signals are set.
Alarm display.
Remedy: For information only. The user must decide what to do.
Program Clear alarm with the Delete key or NC START.
Continuation:
6413 Channel %1 tool %2 has reached its monitoring limit with D = %4
Parameters: %1 = TO unit
%2 = Tool identifier (name)
%3 = -Not used-
%4 = D number
Definitions: Tool monitoring: This message informs that the specified D offset has reached its prewarning limit for
a time-, quantity- or wear-monitored tool. If possible, the D number is displayed; if not, value 0 is
assigned to the 4th parameter.
If the function additive offset is being used, additive offset monitoring may be active instead of tool
wear monitoring.
The actual type of tool monitoring is a tool property (see $TC_TP9).
If replacement tools are not being used, the duplo number specified has no meaning.
The alarm originates during NC program execution.
Reaction: Interface signals are set.
Alarm display.
Remedy: For information only. The user must decide what to do.
Program Clear alarm with the Delete key or NC START.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-73