Siemens SINUMERIK 840Di Diagnostic Manual page 479

11/2006
27206 PROFIsafe: MD %1[%2] maximum number of F user data (%3 bits)
exceeded.
Parameters: %1 = MD name
%2 = MD array index for MD name
%3 = Maximum F user data bits.
Definitions: The parameterized data indicated in the machine data are outside the F user data range of the F
module.
Note
When machine data PROFISAFE_IN/OUT_ADDRESS is displayed, the sub slot address
parameterized in it will exceed the F user data range of the F module.
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Correct the MD.
Program Switch control OFF - ON.
Continuation:
27207 PROFIsafe: MD %1[%2] max. sub slot number: %3 exceeded
Parameters: %1 = MD name
%2 = MD array index for MD name
%3 = Max. number of sub slots
Definitions: The sub slot parameterized in the indicated machine data exceeds the max. permissible number of
sub slots per PROFIsafe module.
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Reduce the number of sub slots by changing the splitting of F user data of the PROFIsafe module.
Program Switch control OFF - ON.
Continuation:
27208 PROFIsafe: MD %1[%2]: max. sub-slot address %3 exceeded.
Parameters: %1 = MD name
%2 = MD array index
%3 = Maximum sub-slot address.
Definitions: A sub-slot address was entered in the MD that is too high. The entered value must not exceed the
displayed maximum sub-slot address.
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Correct the MD.
Program Switch control OFF - ON.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-479