Siemens SINUMERIK 840Di Diagnostic Manual page 843

11/2006
No. 63
Explanation Activate test run (VDI signal: Rapid traverse override)
Cause 1. Nesting depth too great
2. The active block, after which deceleration takes place, cannot be reorganized (occurs
when deceleration takes place over several blocks).
− Wait until the preceding ASUB is complete or abort the program.
Remedy
− Abort program
No. 64
Explanation Deactivate test run (VDI signal: Rapid traverse override)
Cause 1. Nesting depth too great
2. The active block, after which deceleration takes place, cannot be reorganized (occurs
when deceleration takes place over several blocks).
− Wait until the preceding ASUB is complete or
Remedy
− Abort program
No. 65
Explanation Activate read-in disable for main run block (VDI signal: Read-in disable).
Cause -
Remedy -
No. 66
Explanation Deactivate read-in disable for main run block (VDI signal: Read-in disable).
Cause -
Remedy -
No. 67
Explanation Stop at block end (alarm)
Cause -
Remedy -
No. 68
Explanation Stop all axes (alarm)
Cause -
Remedy -
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), Edition 11/2006
List of Action Numbers
3-843