Siemens SINUMERIK 840Di Diagnostic Manual page 355

11/2006
18312 Channel %1 block %2 frame: fine shift not configured
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Fine shift must be configurd with G58 and G59.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify machine data.
Program Clear alarm with the RESET key. Restart part program
Continuation:
18313 Channel %1 block %2 frame: illegal switchover of geometry axes
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: It is not allowed to change the geometry axis assignment because the current frame contains
rotations.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Change NC program or set other mode with $MN_FRAME_GEOAX_CHANGE_MODE.
Program Clear alarm with the RESET key. Restart part program
Continuation:
18314 Channel %1 block %2 frame: type conflict
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: It is not possible to chain global frames and channel-specific frames. The alarm occurs if a global
frame is programmed with a channel axis name and no machine axis on this NCU is assigned to the
channel axis. Channel-specific frames cannot be programmed with machine axis names if there is no
corresponding channel axis on this NCU.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify part program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-355