Siemens SINUMERIK 840Di Diagnostic Manual page 508

Overview of Alarms
NCK alarms
61152 Channel %1 block %2: B axis kinematics (turning technology) either not
or incorrectly set up in Start-up of swivel cycle --> error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Remedy: 1. %4 = A123 -> B axis not an automatic rotary axis under ShopTurn (123 corresponds to parameter
_TCBA)
2. %4 = B123 -> B axis not activated in swiveling start-up (kinematics)
61153 Channel %1 block %2: No 'Rotary axes direct' swivel mode possible -->
error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Remedy: %4 = A -> No tool or cutting edge (D1..) active
61175 Channel %1 block %2: angle of aperture _DF programmed too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The angle of aperture of the text in the engraving cycle is too small. This means that the text for
engraving does not fit in the specified angle.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter a larger angle of aperture.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61176 Channel %1 block %2: text length _DF programmed too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The text length in the engraving cycle is too short. This means that the text for engraving is longer than
the specified text length.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter longer text length
Program Clear alarm with the RESET key. Restart part program
Continuation:
2-508
(123 corresponds to $TC_CARR37[n], n ... number of the swivel data record)
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
© Siemens AG, 2006. All rights reserved
11/2006