Siemens SINUMERIK 840Di Diagnostic Manual page 498

Overview of Alarms
NCK alarms
61099 Channel %1 block %2: Internal cycle error (%4)
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: .
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Clear alarm with the RESET key. Restart part program
Continuation:
61101 Channel %1 block %2: Reference plane incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE71, CYCLE72, CYCLE81 to CYCLE90, CYCLE840,
SLOT1, SLOT2, POCKET1 to POCKET4, LONGHOLE.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: With the relative specification of the depth, either different values for the reference plane and the
retraction plane must be selected or an absolute value must be specified for the depth.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61102 Channel %1 block %2: No spindle direction programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE86, CYCLE87, CYCLE88, CYCLE840, POCKET3,
POCKET4.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Parameter SDIR (or SDR in CYCLE840) must be programmed.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61103 Channel %1 block %2: Number of holes is zero
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No value for the number of holes has been programmed. Alarm triggered by following cycles:
HOLES1, HOLES2.
Remedy: Check parameter NUM.
2-498
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006